HOT ! Worth Discovering｜Tenax Mastidek Cartridge Glue for Conestino Feroe Dekton Stone - Pack of 2｜其他商品

Special Order
Consentino Dekton Mastidek Cartridge Glue Feroe 215 Ml
For use with Dekton Feroe.
Mastidek Cartridge Glue for Cosentino Dekton is a new generation bi-component resin used to glue Dekton. Dekton Mastidek Fast Outdoor Cartridge glue has a very high adhesion in a short amount of time which allows for cutting and polishing the assembled parts in a short time...approximately 45-60 minutes. The hardened product is very shiny and is very polishable.
This product is produced in special cartridges with a 2:1 bi-axial quantity 215 ml. The glue and hardener are pre-dosed in the cartridge which, once inserted in the proper gun, with the special mixer fixed on top, allows the correct extrusion and mixing of the product. Requires use of special M200XMR Cartridge Gun. Suitable for outdoors.
Instructions
All surfaces must be cleaned and free of dust and grease. When applying to a polished or glossy surface it is advised to scrub the surface with sandpaper before gluing. Remove cap and attach the special threaded mixing nozzle. Squeeze out about 6" of product before applying to surface. Clean the nozzle after use, replace the cap and discard the mixing nozzle. Repeat this process at any change of mixer. After usage, clean the nozzle, replace the cap and discard the mixer after. Product will not set below 32°.
Shelf Life
The product in the cartridge will last at least 12 months if stored between 65° and 77°. Keep away from sunlight, heat and humidity.
Safety
Please read the safety data sheet before use and follow the product instructions.



Gel time in bulk at 77º: 2-5 min
Tacky free time at 77º: approx. 15 min
Working time at 77º: 45-60 min
Temp range for use after hardening: -13º to 140º




Typical Technical Data




Viscosity cps 25°C 20 r.p.m.(ASTM D2196)
Tixotropic Liquid


Density at 25°C gr/cm 3

1.27


Aspect
Colored Liquid


Ratio of use glue/hardener
100+50


Gel time (in bulk) at 25° C in min
2min-5min


Time for handling pieces
Approximately 15 min


Working time suggessted at 25°c in min
Approx 45-60 min


Minimum reaction temperature
+1°C


Minimum temperature of use after hardening
-25°C


Maximum temperature of use after hardening
+60°C


Shelf life at 25°C for the WA version
12 months


Adhesion Force in MPa at 25°C on DEKTON, diamond cut surface after 1 hour (ASTM D 4541)
11.0


Adhesion Force in MPa at 25°C on DEKTON, diamond cut surface after 30 days (ASTM D 4541)
12.9





.pdp-description-table{width:100%;}.pdp-table-tr{display:flex;justify-content:space-between;}.pdp-table-td{padding:12px 16px;text-align:left;border:none;}.pdp-table-td:first-child{font-weight:bold;width:30%;}.pdp-table-td:nth-child(2){width:70%;}
Brand:TenaxCategory:AdhesivesSKU:M3HFEROETags:Stone Adhesive